ASTM D5423-23

ASTM D5423-23

Standard Specification for Forced-Convection Laboratory Ovens for Evaluation of Electrical Insulation

Disponibilidad: En stock

48,00 €

Detalles

1.1 This specification covers forced-convection ventilated electrically-heated ovens, operating over all or part of the temperature range from 20?°C above the ambient temperature to 500?°C, and used for thermal endurance evaluation of electrical insulating materials.

1.2 The specification requirements for Type I ovens are based on IEC Publication 60216-4-1, and are technically identical to it. The requirements for Type II ovens are essentially identical to the requirements of Specification D2436. This specification and an associated test method, D5374, have replaced Specification D2436.

1.3 While the ovens covered by this specification are intended primarily for thermal endurance evaluation, their characteristics make them suitable for other applications as applicable.

1.4 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers forced-convection ventilated electrically-heated ovens and used for thermal endurance evaluation of electrical insulating materials. The ovens shall be classified according to ventilations: Type I and Type II. Rate of ventilation, set temperature, temperature variation, and thermal log time properties shall be determined using specified test methods.

Información adicional

Autor American Society for Testing and Materials (ASTM International)
Comité D09.17 - Committee D09 on Electrical and Electronic Insulating Materials
Publicado por ASTM
Tipo de Documento Norma
Tema ,Chemical laboratories. Laboratory equipment
ICS 71.040.10 : Laboratorios químicos. Equipos de laboratorio
Número de páginas 3
Reemplaza ASTM D5423-22
Colección ASTM Volume 10.02 - Multi-User - Single-Site Online
Palabra clave D5423

Te podría(n) interesar también el/los siguiente(s) producto(s)