ASTM B946-23

ASTM B946-23

Standard Test Methods for Surface Roughness of Powder Metallurgy (PM) Products

Disponibilidad: En stock

48,00 €

Detalles

1.1 These test methods cover measuring the surface roughness of powder metallurgy (PM) products at all stages of manufacturing from green compact to fully hardened finished component.

1.2 These test methods provide the definition and schematic of some common surface roughness parameters (Ra, Rt, and RzISO)

1.3 This standard specifies two different standardized procedures for measuring the surface roughness of PM parts.

1.3.1 Method 1 uses a conical stylus and a Gaussian filter.

1.3.2 Method 2 uses a chisel (knife) edge stylus.

1.3.3 Each test method results in a different measure of surface roughness and the results are not directly comparable.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

3.1 The surface roughness of PM parts is an important characteristic in relation to factors such as their load-bearing, wear, sealing, sliding, adhesion, electrical contact, and lubricant retention properties.

3.2 Surface roughness may also be critical for component assembly or system performance. Dimensional fit and mating surface interaction may require certain surface roughness requirements to meet performance specifications.

Información adicional

Autor American Society for Testing and Materials (ASTM International)
Comité B09.05 - Committee B09 on Metal Powders and Metal Powder Products
Publicado por ASTM
Tipo de Documento Norma
Tema ,Metallic coatings,Powder metallurgy
ICS 25.220.40 : Recubrimientos metálicos
77.160 : Metalurgia del polvo
Número de páginas 4
Reemplaza ASTM B946-11(2016)
Colección ASTM Volume 02.05 - Multi-User - Single-Site Online
Palabra clave B946

Te podría(n) interesar también el/los siguiente(s) producto(s)