| Name | Unterstützung | Language | Verfügbarkeit | Datum der Ausstellung | Preis | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Englisch |
gültig |
01.07.2022 |
46,00 € |
|
||
|
PDF |
Englisch |
gültig |
01.07.2022 |
53,00 € |
|
||
Details
1.1 This test method covers the determination of the stiffness of geosynthetics used as turf reinforcement mats (TRMs).
1.2 The method is applicable to TRMs of any fiber content and any number of components.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.
1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use:
4.1 In general this test method is adapted from tests developed for woven fabrics (previously designated as Test Method D1388).
4.2 The cantilever test method may not be suitable for testing products that are very limp or have a marked tendency to curl or twist at a cut edge.
Zusätzliche Information
| Autor | American Society for Testing and Materials (ASTM International) |
|---|---|
| Komitee | D35.05 - Committee D35 on Geosynthetics |
| Veröffentlicht von | ASTM |
| Document type | Normen |
| Thema | ,Plant growing |
| ICS | 65.020.20 : Pflanzenzucht
|
| Seitenzahl | 4 |
| Ersetzt | ASTM D6575/D6575M-16 + Redline |
| Sammlung | ASTM Volume 04.13 - Multi-User - Single-Site Online |
| Schlagwort | D6575/D6575M |
