ASTM D2420-23

ASTM D2420-23

Standard Test Method for Hydrogen Sulfide in Liquefied Petroleum (LP) Gases (Lead Acetate Method)

Verfügbarkeit: Auf Lager

48,00 €

Details

1.1 This test method2 covers the detection of hydrogen sulfide in liquefied petroleum (LP) gases. The sensitivity of the test is about 4?mg/m3 (0.15 to 0.2 grain of hydrogen sulfide per 100?ft3) of gas.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 Liquefied petroleum gases and their products of combustion must not be unduly corrosive to the materials with which they come in contact. The potential personnel exposure hazards of H2S also make the detection and measurement of hydrogen sulfide important, even in low concentrations. In addition, in some cases the odor of the gases shall not be objectionable. (See Specification D1835 and GPA 2140.)

Zusätzliche Information

Autor American Society for Testing and Materials (ASTM International)
Komitee D02.H0 - Committee D02 on Petroleum Products, Liquid Fuels, and Lubricants
Veröffentlicht von ASTM
Document type Normen
Thema ,Gaseous fuels
ICS 75.160.30 : Gasförmige Brennstoffe
Seitenzahl 3
Ersetzt ASTM D2420-13(2018)
Sammlung ASTM Volume 05.01 - Multi-User - Single-Site Online
Schlagwort D2420

Sie könnten auch an folgenden Produkten interessiert sein