| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
01/04/2023 |
54,00 € |
|
||
|
PDF |
Anglais |
Active |
01/04/2023 |
65,00 € |
|
||
Détails
1.1 This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium-15 molybdenum alloy to be used in the manufacture of surgical implants (1).2
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents, therefore, to ensure conformance with the standard, each system shall be used independently of each other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers the chemical, mechanical, and metallurgical requirements for wrought titanium-15 molybdenum alloy to be used in the manufacture of surgical implants. The product shall be classified as: strip, sheet, plate, bar, or wire. The heat analysis shall conform to the chemical composition prescribed. Material shall be furnished in the beta annealed condition. Bend tests and tension tests shall be performed to conform to the specified requirements.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | F04.12 - Committee F04 on Medical and Surgical Materials and Devices |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Surgical instruments and materials |
| ICS | 11.040.30 : Instruments et matériaux chirurgicaux
|
| Nombre de pages | 6 |
| Remplace | ASTM F2066-18 |
| Recueil | ASTM Volume 13.01 - Multi-User - Single-Site Online |
| Mot-clé | F2066 |
