ASTM E2510-20

ASTM E2510-20

Standard Test Method for Torque Calibration or Conformance of Rheometers

Disponibilité: En stock.

46,00 €

Détails

1.1 ,This test method describes the calibration or performance conformance for the torque signal generated by commercial or custom-built rheometers. The specific range of the test depends upon the torque range of the rheometer.

1.2 ,The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 ,The test method calibrates or demonstrates conformity of the torque signal of a rheometer at ambient temperature.

5.2 ,A calibration factor thus determined may be used to obtain correct torque values.

5.3 ,This test method may be used in research, development, specification acceptance, and quality control or assurance.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité E37.08 - Committee E37 on Thermal Measurements
Edité par ASTM
Type de document Norme
Thème ,Measurement of volume, mass, density, viscosity
ICS 17.060 : Mesurage de volume, masse, densité, viscosité
Nombre de pages 4
Remplace ASTM E2510-07(2013)
Recueil ASTM Volume 14.01 - Multi-User - Single-Site Online
Historique ,
Mot-clé E2510

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)