| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
01/03/2022 |
46,00 € |
|
||
|
PDF |
Anglais |
Active |
01/03/2022 |
53,00 € |
|
||
Détails
1.1 This test method covers a procedure for rapidly deforming by impact an EIFS for evaluating the effect of such deformation.
1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents, therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use:
5.1 This specification determines levels of impact resistance under Classes PB and PI EIFS.
5.2 This test method does not purport to simulate impact encountered in service.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | E06.58 - Committee E06 on Performance of Buildings |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Test conditions and procedures in general |
| ICS | 19.020 : Procédures et conditions d'essai en général
|
| Nombre de pages | 2 |
| Remplace | ASTM E2486/E2486M-13(2018) |
| Recueil | ASTM Volume 04.12 - Multi-User - Single-Site Online |
| Historique | ,, |
| Mot-clé | E2486/E2486M |
