ASTM E1423-21 + Redline

ASTM E1423-21 + Redline

Standard Practice for Determining Steady State Thermal Transmittance of Fenestration Systems

Disponibilité: En stock.

68,00 €

Détails

1.1 This practice covers standard test specimen sizes and test conditions as well as the calculation and presentation of the thermal transmittance and conductance data measured in accordance with Test Method C1199. The standard sizes and conditions are to be used for fenestration product comparison purposes. The specifier may choose other sizes and conditions for product development or research purposes.

1.2 This practice deals with the determination of the thermal properties of a fenestration system installed vertically without the influences of solar heat gain and air leakage effects.

Note 1: To determine air leakage effects of fenestration systems, Test Method E283/E283M or E1424 should be referenced.

Note 2: See Appendix X1 regarding garage doors and rolling doors.

1.3 This practice specifies the procedure for determining the standardized thermal transmittance of a fenestration test specimen using specified values of the room-side and weather-side surface heat transfer coefficients, hh and hc, respectively.

1.4 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.5 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 This practice details the test specimen sizes and test conditions, namely, the room-side and weather-side air temperatures, and the surface heat transfer coefficients for both sides of the test specimen, when testing fenestration products in accordance with Test Method C1199.

4.2 The thermal transmittance and conductance of a specimen are affected by its size and three-dimensional geometry. Tests should therefore be conducted using the specimen sizes recommended in 5.1. Should the specimen size differ from those given in 5.1, the actual size shall be reported in the test report.

4.3 Many factors can affect the thermal performance of a fenestration system, including deflections of sealed glazing units. Care should be exercised to maintain the original physical condition of the fenestration system and while installing it in the surround panel.

4.4 The thermal transmittance and conductance results obtained do not, and are not intended, to reflect performances expected from field installations since they do not account for solar radiation and air leakage effects. The thermal transmittance and conductance results are taken from specified laboratory conditions and are to be used only for fenestration product comparisons and as input to thermal performance analyses that also include solar and air leakage effects.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité E06.51 - Committee E06 on Performance of Buildings
Edité par ASTM
Type de document Norme
Thème ,Doors and windows,Thermal insulation of buildings
ICS 91.060.50 : Portes et fenêtres
91.120.10 : Isolation thermique des bâtiments
Nombre de pages 12
Remplace ASTM E1423-14 + Redline
Recueil ASTM Volume 04.11 - Multi-User - Single-Site Online
Historique ,,
Mot-clé E1423

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)