ASTM E1307-18

ASTM E1307-18

Standard Practice for Surface Preparation and Structural Adhesive Bonding of Precured, Nonmetallic Composite Facings to Structural Core for Flat Shelter Panels

Disponibilité: En stock.

51,00 €

Détails

1.1 ,This practice covers the materials, processes, and quality controls to be used in the manufacture of durable adhesive bonded, nonmetallic faced, flat sandwich panels for rigid wall relocatable shelters.

1.2 ,The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.

1.3 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 ,Durable adhesive bonds of composite laminates can be obtained reliably only through proper selection and careful control of the materials used and the steps in the bonding process. The preparation of the composite laminates to obtain surfaces with appropriate characteristics is a critical step. Improper surface preparation can produce seemingly acceptable bonds that can degrade rapidly with time. This practice describes how properly prepared surfaces can be obtained.

4.2 ,The formation of reproducible, durable, adhesive bonds in structural units requires great care in the selection of materials, the preparation of the surfaces of the parts to be bonded, the fit of parts, and the performance of the steps in the bonding process. Experience has shown that adhesive bonding carried out in accordance with this practice produces reproducible bonds.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité E06.53 - Committee E06 on Performance of Buildings
Edité par ASTM
Type de document Norme
Thème ,Wood-based panels in general
ICS 79.060.01 : Panneaux à base de bois en général
Nombre de pages 5
Remplace ASTM E1307-10
Recueil ASTM Volume 04.11 - Multi-User - Single-Site Online
Historique ,,
Mot-clé E1307

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)