ASTM E1070-17a

ASTM E1070-17a

Standard Test Method for Determination of Phosphorus in Iron Ores by Phospho-Molybdenum-Blue Spectrophotometry

Disponibilité: En stock.

46,00 €

Détails

1.1 ,This test method covers the determination of phosphorus in iron ores, concentrates, and agglomerates in the range from 0.005 % to 1.0 ,% phosphorus.

1.2 ,The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 ,This test method has been evaluated in accordance with Practice E1601 and Guide E1763. Unless otherwise noted in the precision and bias section, the lower limit in the scope of each method specifies the lowest analyte content that may be analyzed with acceptable error (defined as a nominal 5 % risk of obtaining a 50 % or larger relative difference in results on the same test sample in two laboratories).

1.4 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory limitations prior to use.

1.5 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 ,This test method for the analysis of iron ore concentrates and agglomerates is primarily intended as a referee method to test for compliance with compositional specifications. It is assumed that users of this test method will be trained analysts capable of performing common laboratory procedures skillfully and safely. It is expected that work will be performed in a properly-equipped laboratory and that proper waste disposal procedures will be followed. Appropriate quality control practices shall be followed, such as those described in Guide E882.

5.2 ,The determination of this element is needed for international trade and primary iron and steel making.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité E01.02 - Committee E01 on Analytical Chemistry for Metals, Ores, and Related Materials
Edité par ASTM
Type de document Norme
Thème ,Iron ores
ICS 73.060.10 : Minerais de fer
Nombre de pages 4
Remplace ASTM E1070-17
Recueil ASTM Volume 03.05 - Multi-User - Single-Site Online
Historique ,,,
Mot-clé E1070

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)