ASTM D8049-21

ASTM D8049-21

Standard Test Method for Determining Concentration, Count, and Size Distribution of Solid Particles and Water in Light and Middle Distillate Fuels by Direct Imaging Analyzer

Disponibilité: En stock.

57,00 €

Détails

1.1 This test method uses a direct imaging analyzer to count and measure the size and shape of dispersed solid particles and water droplets in light and middle distillate fuels in the overall range from 4?µm to 100?µm and in size bands of =4?µm, =6?µm, and =14?µm.

Note 1: Particle size data from 0.7?µm through 300?µm is available for use or reporting if deemed helpful.

Note 2: Shape is used to classify particles, droplets, and bubbles and is not a reporting requirement.

1.2 The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 This test method is intended for use in the laboratory or in the field for evaluating the cleanliness of fuels identified in the scope.

5.2 Detection of particles and water can indicate degradation of the fuel condition. Particles, whether inorganic or organic, can cause fouling of fuel filters and damage pumps, injectors, and pistons. Knowledge of particle size in relation to metallurgy can provide vital information, especially if the hardness of the solid particles are known from other sources.

Note 3: The method includes the detection of water, solids, and air bubbles. The air bubbles are screened out of the data prior to analysis of results, based on shape and transparency, and are not reported in the results.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité D02.14 - Committee D02 on Petroleum Products, Liquid Fuels, and Lubricants
Edité par ASTM
Type de document Norme
Thème ,Liquid fuels
ICS 75.160.20 : Combustibles liquides
Nombre de pages 11
Remplace ASTM D8049-19a
Recueil ASTM Volume 05.04 - Multi-User - Single-Site Online
Historique ,,,,
Mot-clé D8049

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)