ASTM D6924-03(2017) + Redline

ASTM D6924-03(2017) + Redline

Standard Specification for Preformed Thermoplastic Vulcanizate Elastomeric Joint Seals for Bridges

Disponibilité: En stock.

53,00 €

Détails

1.1 ,This specification covers the material requirements for preformed thermoplastic vulcanizate (TPV) elastomeric joint seals for bridges. The seal consists of a multiple-web design composed of a TPV and functions only by compression of the seal between the faces of the joint with the seal folding inward at the top to facilitate compression. The seal is installed with a lubricant adhesive and is designed to seal the joint and reject incompressibles.

Note 1: ,This specification may not be applicable for seals whose height is less than 90 ,% of its nominal width.

1.2 ,The values stated in inch-pound units are to be regarded as the standard. The values given in parentheses are provided for information only.

1.3 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety and health practices and determine the applicability of regulatory requirements prior to use.

1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers the material requirements for preformed thermoplastic vulcanizate (TPV) elastomeric joint seals for bridges. The seal consists of a multiple-web design composed of a TPV and functions only by compression of the seal between the faces of the joint with the seal folding inward at the top to facilitate compression. The seal is installed with a lubricant adhesive and is designed to seal the joint and reject incompressibles. The physical properties for which the seals shall be tested on and conform accordingly to are tensile strength, elongation at break, hardness, oven aging, ozone resistance, low- and high-temperature recovery, and compression-deflection properties.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité D04.34 - Committee D04 on Road and Paving Materials
Edité par ASTM
Type de document Norme
Thème ,Seals,Bridge construction
Date de confirmation 2017-07-01
ICS 83.140.50 : Joints d'étanchéité
93.040 : Construction des ponts
Nombre de pages 4
Remplace ASTM D6924-03(2012) + Redline
Recueil ASTM Volume 04.03 - Multi-User - Single-Site Online
Mot-clé D6924

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)