| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
01/08/2019 |
51,00 € |
|
||
|
PDF |
Anglais |
Active |
01/08/2019 |
61,00 € |
|
||
Détails
1.1 ,This specification covers the fabrication of wood boxes. These wood boxes, when constructed, filled and closed, shall be used for the packing of contents not exceeding 1000 lb [454 kg].
1.2 ,If the use of other construction methods or techniques is acceptable and permitted (see 5.1), the resulting boxes shall be of equal or better performance than would result from the use of the specified materials and procedures. An appropriate distribution cycle, specified in Practice D4169, can be used to develop comparative procedures and criteria.
1.3 ,The values stated in either inch-pound or SI units are to be regarded separately as standard. Within the text, the SI units are shown in brackets. The values stated in each system are not exact equivalents, therefore, each system must be used independently of the other. Combining values from the two systems may result in nonconformance with the standard. See IEEE/ASTM SI-10 for conversion of units.
1.4 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers the fabrication methods for the production of wood boxes. The wood boxes produced are classified into two classes according to durability, six styles according to cleat and joint structure, and two treatment types. It is recommended that the boxes be made from recycled materials using standard-compliant fasteners. Each box side and joint should be assembled according to the recommended procedures.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | D10.12 - Committee D10 on Packaging |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Cases. Boxes. Crates |
| ICS | 55.160 : Boîtes. caisses. cageots
|
| Nombre de pages | 9 |
| Remplace | ASTM D6880/D6880M-11 |
| Recueil | ASTM Volume 15.10 - Multi-User - Single-Site Online |
| Historique | , |
| Mot-clé | D6880/D6880M |
