| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
15/05/2022 |
51,00 € |
|
||
|
PDF |
Anglais |
Active |
15/05/2022 |
61,00 € |
|
||
Détails
1.1 This practice describes procedures for collecting and handling a coal sample from a core recovered from a borehole.
1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents, therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.
1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Significance and Use:
5.1 A properly collected sample that includes the total coal bed interval provides a sample that is a representative cross section of the coal bed at the point of sampling. Core samples are taken for subsequent testing needed for evaluation of coal quality and characterization for commercial evaluations, for planning of mining operations to maintain coal quality, for the determination of coal rank in accordance with Classification D388, and for geologic coal resource studies.
Note 1: Because of the potential for lateral variability, a sample may not represent the quality of the coal bed at another sample point. The reliability of the data generated from core samples is dependent on the number and spacing of the sample points and the variability of the coal characteristics in a given area.
5.2 Moisture determined directly from a core sample shall be considered questionable in any core sample because of possible contamination from drilling fluids and groundwater. If a more representative estimate of the inherent moisture content of the core sample (with the exception of certain low-rank coals) is desired, the sample should be analyzed according to Test Method D1412.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | D05.23 - Committee D05 on Coal and Coke |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Coals |
| ICS | 73.040 : Charbon
|
| Nombre de pages | 6 |
| Remplace | ASTM D5192-09(2015) |
| Recueil | ASTM Volume 05.06 - Multi-User - Single-Site Online |
| Mot-clé | D5192/D5192M |
