ASTM D2872-22

ASTM D2872-22

Standard Test Method for Effect of Heat and Air on a Moving Film of Asphalt Binder (Rolling Thin-Film Oven Test)

Disponibilité: En stock.

54,00 €

Détails

1.1 This test method is intended to measure the effect of heat and air on a moving film of semi-solid asphaltic materials. The effects of this treatment are determined from measurements of the selected properties of the asphalt before and after the test.

1.2 The values stated in inch-pound units are to be regarded as the standard.

1.3 The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 This test method indicates approximate change in properties of asphalt during conventional hot-mixing at about 302?°F (150?°C) as indicated by viscosity and other rheological measurements. It yields a residue which approximates the asphalt condition as incorporated in the pavement. If the mixing temperature differs appreciably from the 302?°F (150?°C) level, more or less effect on properties will occur. This test method can also be used to determine mass change, which is a measure of asphalt volatility.

Note 1: The quality of results produced by this standard is dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors, following the suggestions of Specification D3666 or some similar acceptable guidance provides a means of evaluating and controlling some of those factors.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité D04.46 - Committee D04 on Road and Paving Materials
Edité par ASTM
Type de document Norme
Thème ,Binders. Sealing materials,Road construction materials
ICS 91.100.50 : Liants. matériaux d'étanchéité
93.080.20 : Matériaux de construction des routes
Nombre de pages 6
Remplace ASTM D2872-21
Recueil ASTM Volume 04.03 - Multi-User - Single-Site Online
Mot-clé D2872

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)