ASTM D2291/D2291M-22 + Redline

ASTM D2291/D2291M-22 + Redline

Standard Practice for Fabrication of Ring Test Specimens for Glass-Resin Composites

Disponibilité: En stock.

57,00 €

Détails

1.1 This practice is intended for use in the fabrication of ring-type test specimens to be used in the evaluation of the mechanical properties of reinforcement and resins in a composite structure. The practice outlines the steps in the preparation of the test specimens, including the final specimen machining where applicable. Three final ring configurations are included.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: There is no known ISO equivalent to this practice.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 This practice provides a uniform procedure for fabricating glass fiber/thermoset resin ring samples for use as test specimens. Specimens so prepared can be used in Test Methods D2290 and D2344/D2344M.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité D20.18 - Committee D20 on Plastics
Edité par ASTM
Type de document Norme
Thème ,Films and sheets
ICS 83.140.10 : Films et feuilles
Nombre de pages 4
Remplace ASTM D2291/D2291M-16 + Redline
Recueil ASTM Volume 08.01 - Multi-User - Single-Site Online
Mot-clé D2291/D2291M

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)