ASTM D2051-14(2022)

ASTM D2051-14(2022)

Standard Test Method for Durability of Finish of Zippers to Laundering

Disponibilité: En stock.

46,00 €

Détails

1.1 This test method covers the determination of the durability of the enamel or other decorative coating of a zipper when subjected to laundering.

1.2 The values stated in SI units are to be regarded as standard. The values given in parentheses after SI units are provided for information only and are not considered standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 Test Method D2051 is useful for testing to determine the effect of repeated laundering on the appearance of the decorative coating of a zipper.

5.2 This test method is considered satisfactory for acceptance testing of commercial shipments because the method has been used extensively in the trade for acceptance testing.

5.2.1 If there are differences of practical significance between reported test results for two laboratories (or more), comparative test should be performed to determine if there is a statistical bias between them, using competent statistical assistance. As a minimum, the test samples should be used that are as homogeneous as possible, that are drawn from the material from which the disparate test results were obtained, and that are randomly assigned in equal numbers to each laboratory for testing. Other materials with established test values may be used for this purpose. The test results from the two laboratories should be compared using a statistical test for unpaired data, at a probability level chosen prior to the testing series. If a bias is found, either its cause must be found and corrected, or future test results must be adjusted in consideration of the known bias.

5.3 The test method(s) in the standard along with those in Test Methods D2052, D2053, D2054, D2057, D2058, D2059, D2060, D2061, and D2062 are a collection of proven test methods. They can be used as aids in the evaluation of zippers without the need for a thorough knowledge of zippers. The enumerated test methods do not provide for the evaluation of all zipper properties. Besides those properties measured by means of the enumerated test methods there are other properties that may be important for the satisfactory performance of a zipper. Test methods for measuring those properties have not been published either because no practical methods have yet been developed or because a valid evaluation of the information resulting from existing unpublished methods requires an intimate and thorough knowledge of zippers.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité D13.54 - Committee D13 on Textiles
Edité par ASTM
Type de document Norme
Thème ,Headgear. Clothing accessories. Fastening of clothing
Date de confirmation 2022-03-01
ICS 61.040 : Coiffures. accessoires d'habillage. dispositif de fermeture
Nombre de pages 2
Remplace ASTM D2051-14
Recueil ASTM Volume 07.01 - Multi-User - Single-Site Online
Historique ,,,
Mot-clé D2051

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)