ASTM C1328/C1328M-23 + Redline

ASTM C1328/C1328M-23 + Redline

Standard Specification for Plastic (Stucco) Cement

Disponibilité: En stock.

57,00 €

Détails

1.1 This specification covers two types of plastic cement for use in portland cement-based plasters for exterior (stucco) and interior application.

1.2 Units—The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard. Values in SI units shall be obtained by measurement in SI units or by appropriate conversion, using the Rules for Conversion and Rounding given in Standard IEEE/ASTM?SI?10, of measurements made in other units. Values are stated in only SI units when inch-pound units are not used in practice.

1.3 The text of this standard refers to notes and footnotes that provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.4 The following safety hazards caveat pertains only to Sections 13 and 14. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use. (Warning—Fresh hydraulic cementitious mixtures are caustic and may cause chemical burns to skin and tissue upon prolonged exposure.)2

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers plastic cements for use in Portland cement-based plasters for exterior (stucco) and interior applications. All the materials should be tested and conform to the required values of fineness, autoclave expansion, time of setting, compressive strength, air content of mortar, and water retention. The cement should be stored in a way that permits easy access and inside a suitable weathertight building.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité C01.11 - Committee C01 on Cement
Edité par ASTM
Type de document Norme
Thème ,Cement. Gypsum. Lime. Mortar
ICS 91.100.10 : Ciment. Plâtre. Chaux. Mortier
Nombre de pages 4
Remplace ASTM C1328/C1328M-19 + Redline
Recueil ASTM Volume 04.01 - Multi-User - Single-Site Online
Mot-clé C1328/C1328M

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)