ASTM C1247-20

ASTM C1247-20

Standard Test Method for Durability of Sealants Exposed to Continuous Immersion in Liquids

Disponibilité: En stock.

46,00 €

Détails

1.1 ,This test method covers a laboratory procedure that assists in determining the durability of a sealant and its adhesion to a substrate while continuously immersed in a liquid. This method tests the influence of a liquid on the sealant and its adhesion to a substrate. It does not test the added influence of constant stress from hydrostatic pressure that is often present with sealants used in submerged and below-grade applications, nor does it test the added influence of stress from joint movement while immersed. This method also does not (in its standard form) test the added influence of acids or caustics or other materials that may be in the liquid, in many applications.

1.2 ,The values stated in SI units are to be regarded as the standard. The inch-pound given in parentheses are provided for information only.

1.3 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 ,This test method uses elevated temperature in an attempt to accelerate the degradation of a sealant and its adhesion to a substrate. This test method is an accelerated method and will only be a predictor of long-term durability if the actual service temperature is significantly lower than the elevated test temperature.

5.2 ,This test method can be used as an indicator of longevity but direct correlation to actual use will be difficult for many applications.

5.3 ,The correlation of data from this test method to applications where the sealant joint will have wet and dry cycles will be difficult since, with some sealants on some substrates, adhesion that is lost during wet periods is regained during dry periods.

5.4 ,This test method is performed in a hot liquid and may be considered an acceleration of deterioration of the sealant or the sealant's adhesion to a substrate. Compared to how the sealant will be used in some applications, in some cases, this test may be less severe than the actual application. The benefit from the use of this test method will depend on the comparison of the conditions of this test to the actual conditions of use (temperature, duration, nature of substrate, composition of the liquid).

5.5 ,To determine the ability of a sealant to perform in a given application, modification of this procedure will often be required and is permissible, as mutually agreed upon by interested parties.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité C24.30 - Committee C24 on Building Seals and Sealants
Edité par ASTM
Type de document Norme
Thème ,Binders. Sealing materials
ICS 91.100.50 : Liants. matériaux d'étanchéité
Nombre de pages 4
Remplace ASTM C1247-14
Recueil ASTM Volume 04.07 - Multi-User - Single-Site Online
Historique ,,,
Mot-clé C1247

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)