ASTM B911/B911M-22 + Redline

ASTM B911/B911M-22 + Redline

Standard Specification for ACSR Twisted Pair Conductor (ACSR/TP)

Disponibilité: En stock.

53,00 €

Détails

1.1 This specification covers ACSR Twisted Pair Conductor (ACSR/TP) for use as overhead electric conductors (see Notes 1 and 2).

Note 1: The conductor is fabricated from two component ACSR conductors of the same size twisted helically around each other. This conductor is identified by the code name of the component ACSR conductor followed by /TP or the size and type of the component ACSR conductor followed by /TP.

Note 2: There are registered trademark symbols that are also used to identify the twisted pair notation. Consult cable manufacturers for additional details.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.

1.2.1 For conductor sizes designated by AWG or kcmil, the requirements in SI units have been numerically converted from corresponding values stated or derived in inch-pound units. For conductor sizes designated by SI units only, the requirements are stated or derived in SI units. For density, resistivity, and temperature, the values stated in SI units are to be regarded as standard.

1.3 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers ACSR twisted pair conductor for use as overhead electric conductors. The conductors shall conform to the required values of equivalent size AWG, outer dimensions, nominal mass, rated strength, resistance and shall conform to the required component composition of aluminum and steel. . Tests for the electrical and mechanical properties shall be made on the component conductors.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité B01.07 - Committee B01 on Electrical Conductors
Edité par ASTM
Type de document Norme
Thème ,Wires and symmetrical cables
ICS 33.120.20 : Fils et câbles symétriques
Nombre de pages 4
Remplace ASTM B911/B911M-12(2016) + Redline
Recueil ASTM Volume 02.03 - Multi-User - Single-Site Online
Mot-clé B911/B911M

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)