| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
01/11/2022 |
48,00 € |
|
||
|
PDF |
Anglais |
Active |
01/11/2022 |
57,00 € |
|
||
Détails
1.1 This specification establishes the requirements for Copper Alloy UNS Nos. C17500, C17510, C17540, and C17465 rod and bar in straight lengths.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units, which are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and to determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification establishes the requirements for copper-cobalt-beryllium alloy (UNS No. C17500), copper-nickel-beryllium alloy (UNS No. C17510), and copper-nickel-lead-beryllium alloy (UNS No. C17465) rods and bars in straight lengths. Tempers available under this specification are: TB00 (solution heat treated (A)), TF00 (precipitation hardened (AT)), TD04 (solution heat treated and cold worked: hard (H)), and TH04 (hard and precipitation heat treated (HT)). Materials shall be tested and adhere to mechanical (tensile strength and Rockwell hardness), electrical conductivity, and chemical composition requirements.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | B05.02 - Committee B05 on Copper and Copper Alloys |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Copper products |
| ICS | 77.150.30 : Produits en cuivre
|
| Nombre de pages | 4 |
| Remplace | ASTM B441-16 + Redline |
| Recueil | ASTM Volume 02.01 - Multi-User - Single-Site Online |
| Mot-clé | B441 |
