| Nom | Support | Langue | Disponibilité | Date d'édition | Prix | ||
|---|---|---|---|---|---|---|---|
|
PDF |
Anglais |
Active |
01/05/2022 |
51,00 € |
|
||
|
PDF |
Anglais |
Active |
01/05/2022 |
61,00 € |
|
||
Détails
1.1 This specification establishes the requirements for seamless copper and copper-alloy rectangular tube intended for use as transmission lines in electronic equipment. Five types of material are specified having the following nominal compositions:2
| Copper or | ?Previously | Nominal Composition, % | ||
| ?Copper | ?Zinc | Phosphorus | ||
|
|
|
|
|
|
| C10100 | Copper, Type OFEA | 99.99B | ... | ... |
| C10200 | Copper, Type OFA | 99.95B | ... | ... |
| C10300 | Copper, Type OFXLPA | 99.95B | ... | 0.003 |
| C12000 | Copper, Type DLPA | 99.90B | ... | 0.008 |
| C22000 | Commercial | 90 | 10 | ... |
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The following safety hazard caveat pertains only to the test method(s) described in this specification.
1.3.1 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers seamless copper and copper-alloy rectangular waveguide tube intended for use as transmission lines in electronic equipment. Four types of material are specified having the following nominal compositions: C10200, C10300, C12000, and C22000. The copper and copper-alloy tubes shall be finished by such cold-working and annealing operations as are necessary to meet the required properties. The material shall conform to the chemical requirements specified. The material shall conform to the Rockwell hardness requirements prescribed. The test specimens of copper UNS nos. C10200, C10300, and C12000 shall be free of cuprous oxide. It is to be expected that samples of Copper UNS Nos. C10200, C10300, and C12000 shall be capable of passing the embrittlement test. It is to be expected that samples of copper UNS nos. C10200, C10300, and C12000 will conform to the prescribed electrical resistivity requirements. Samples for chemical analysis shall be taken accordingly.
Significance and Use:
15.1 For purposes of determining compliance with the specified limits for requirements of chemical composition, hardness, and electrical resistivity, an observed value or a calculated value shall be rounded as indicated in accordance with the rounding method of Practice E29.
Informations supplémentaires
| Auteur | American Society for Testing and Materials (ASTM International) |
|---|---|
| Comité | B05.04 - Committee B05 on Copper and Copper Alloys |
| Edité par | ASTM |
| Type de document | Norme |
| Thème | ,Copper products |
| ICS | 77.150.30 : Produits en cuivre
|
| Nombre de pages | 7 |
| Remplace | ASTM B372-17 + Redline |
| Recueil | ASTM Volume 02.01 - Multi-User - Single-Site Online |
| Mot-clé | B372 |
