ASTM A705/A705M-23

ASTM A705/A705M-23

Standard Specification for Age-Hardening Stainless Steel Forgings

Disponibilité: En stock.

54,00 €

Détails

1.1 This specification2 covers age-hardening stainless steel forgings for general use.

1.2 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents, therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.3 Unless the order specifies an “M” designation, the material shall be furnished to inch-pound units.

Note 1: Bar products are covered by Specification A564/A564M.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers age-hardening stainless steel forgings for general use. Materials for forgings shall consist of billets or bars and shall either be forged, rolled, or cast or a section cut from an ingot. The steel specimens shall be solution annealed and age hardened and shall conform to the required values of tensile strength, yield strength, elongation, reduction of area, hardness and impact Charpy-V. The steel materials shall conform to the required chemical compositions of carbon, manganese, phosphorus, sulfur, silicon, chromium, nickel, aluminum, molybdenum, titanium, copper, nitrogen, columbium, and tantalum.

Informations supplémentaires

Auteur American Society for Testing and Materials (ASTM International)
Comité A01.17 - Committee A01 on Steel, Stainless Steel and Related Alloys
Edité par ASTM
Type de document Norme
Thème ,Iron and steel forgings
ICS 77.140.85 : Pièces forgées
Nombre de pages 8
Remplace ASTM A705/A705M-22
Recueil ASTM Volume 01.03 - Multi-User - Single-Site Online
Mot-clé A705/A705M

Vous pourriez aussi être intéressé(e) par le(s) produit(s) suivant(s)