ASTM F2660-20 + Redline

ASTM F2660-20 + Redline

Standard Test Method for Qualifying Coatings for Use on F3125 Grade A490 Structural Bolts Relative to Environmental Hydrogen Embrittlement

Availability: In stock

€61.00

Details

1.1 ,This test method defines the procedures and tests to evaluate the effect of a coating system on the susceptibility to environmental hydrogen embrittlement (EHE) of an ASTM F3125 Grade A490 high strength structural bolt.

1.2 ,This test method shall qualify a coating system for use with any size of F3125 Grade A490 bolts (that is, 1/2 ,to 1-1/2 ,in.) high strength structural bolts, relative to EHE.

1.3 ,The characteristic to be evaluated by this test method is the susceptibility to EHE caused by hydrogen generated from corrosion protection of the steel bolt by sacrificial galvanic corrosion of the coating. Testing shall be performed on coated, specimen ASTM F3125 Grade A490 bolts manufactured to the maximum susceptible tensile strength values (see Table 1) of the bolt (see Section 5 Specimen Bolt Requirements). The internal hydrogen embrittlement (IHE) susceptibility will also be inherently evaluated when the EHE is tested through this test method. There is no need for a separate IHE susceptibility test.

1.4 ,The values stated in inch-pound units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.6 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 ,This test method describes the testing procedure that shall be used to qualify a coating system that is under consideration for use on ASTM F3125 Grade A490 high strength structural bolts made of any steel composition permitted by the F3125 specification for Grade A490 bolts. The test method measures the susceptibility of coated specimen bolts to the influence of an externally applied potential (see 7.2.3.3) by testing for the threshold of embrittlement in a salt solution environment.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee F16.01 - Committee F16 on Fasteners
Published by ASTM
Document type Standard
Theme ,Bolts, screws, studs
ICS 21.060.10 : Bolts, screws, studs
Number of pages 7
Replace ASTM F2660-13 + Redline
Set ASTM Volume 01.09 - Multi-User - Single-Site Online
Document history ,
Keyword F2660

You may also be interested in the following product(s)