| Name | Support | Language | Availability | Edition date | Price | ||
|---|---|---|---|---|---|---|---|
|
PDF |
English |
Active |
1/1/2015 |
€46.00 |
|
||
|
PDF |
English |
Active |
1/1/2015 |
€53.00 |
|
||
Details
1.1 ,This specification covers monitoring devices (monitors) for the automatic detection and signaling of low insulation resistance values in idle electrical motors or generators, or both.
1.2 ,Monitors are intended for permanent installation in both existing or new panels and controller enclosures designed for marine application.
1.3 ,The values stated in SI units are to be regarded as standard. The values given in parentheses are mathematical conversions to inch-pound units that are provided for information only and are not considered standard.
1.4 ,The following safety hazards caveat pertains only to the test method described in this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers monitoring devices (monitors) for the automatic detection and signaling of low insulation resistance values in idle electrical motors or generators, or both. Monitors are intended for permanent installation in both existing or new panels and controller enclosures designed for marine application. These insulation resistance monitors shall be classified in four types: Type I are alternating current generator monitors, Type II are alternating current generator monitors, Type III are direct current motor monitors, and Type IV are direct current generator monitors. The enclosure materials used in the construction of the monitors are to be flame-retardant and the current carrying terminals shall be made of corrosion resistant material. The monitors shall isolate their measuring circuit from the line voltage, while the motor is operating, by the use of an integral isolating relay. In the design of these monitors, environmental factors shall be considered: operating temperature range, sealing, inclination, humidity, and vibration. Also, the monitor relays, voltage characteristics and operating accuracy shall be considered in the design of these monitors. Each monitor shall be subjected to the following: visual and mechanical examination and operational test.
Additional Info
| Author | American Society for Testing and Materials (ASTM International) |
|---|---|
| Committee | F25.10 - Committee F25 on Ships and Marine Technology |
| Published by | ASTM |
| Document type | Standard |
| Theme | ,Marine engines and propulsion systems |
| Confirmation date | 2019-07-01 |
| ICS | 47.020.20 : Marine engines and propulsion systems
|
| Number of pages | 3 |
| Replace | ASTM F1134-15e1 |
| Set | ASTM Volume 01.07 - Multi-User - Single-Site Online |
| Document history | ,,,,, |
| Keyword | F1134 |
