ASTM E2253-21 + Redline

ASTM E2253-21 + Redline

Standard Test Method for Temperature and Enthalpy Measurement Validation of Differential Scanning Calorimeters

Availability: In stock

€61.00

Details

1.1 This test method provides procedures for validating temperature and enthalpy measurements of differential scanning calorimeters (DSC) and analytical methods based upon the measurement of temperature or enthalpy (or heat), or both, by DSC. Performance parameters determined include temperature and calorimetric repeatability (precision), detection limit, quantitation limit, linearity, and bias. This test method is applicable to exothermic events.

1.2 Validation of apparatus performance and analytical methods is requested or required for quality initiatives or where results may be used for legal purposes.

1.3 The values stated in SI units are to regarded as standard. No other units of measurement are included in this standard.

1.4 This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 This test method may be used to determine and validate the performance of a particular DSC apparatus.

5.2 This test method may be used to determine and validate the performance of a particular method based upon a DSC temperature and enthalpic measurement, or both.

5.3 This test method may be used to determine the repeatability of a particular apparatus, operator, or laboratory.

5.4 This test method may be used for specification and regulatory compliance purposes.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee E37.10 - Committee E37 on Thermal Measurements
Published by ASTM
Document type Standard
Theme ,Heat. Calorimetry
ICS 17.200.10 : Heat. Calorimetry
Number of pages 7
Replace ASTM E2253-16 + Redline
Set ASTM Volume 14.01 - Multi-User - Single-Site Online
Document history ,,,,
Keyword E2253

You may also be interested in the following product(s)