ASTM D7405-20

ASTM D7405-20

Standard Test Method for Multiple Stress Creep and Recovery (MSCR) of Asphalt Binder Using a Dynamic Shear Rheometer

Availability: In stock

€46.00

Details

1.1 ,This test method covers the determination of percent recovery and non-recoverable creep compliance of asphalt binders by means of multiple stress creep and recovery (MSCR) testing. The MSCR test is conducted using the dynamic shear rheometer (DSR) at a specified temperature.

1.2 ,This standard is appropriate for unaged material, material aged in accordance with Test Method D2872 (RTFOT), material aged in accordance with Practice D6521 (PAV), and material aged in accordance with both Test Method D2872 and Practice D6521.

Note 1: ,The majority of development work on this test method was performed on material aged in accordance with Test Method D2872 (RTFOT).

1.3 ,The percent recovery is intended to provide a means to determine the presence of elastic response and stress dependence of polymer-modified and unmodified asphalt binders.

1.4 ,The values stated in SI units are to be regarded as standard. No other units of measurement are included in this standard.

1.5 ,The text of this standard references notes and footnotes which provide explanatory material. These notes and footnotes (excluding those in tables and figures) shall not be considered as requirements of the standard.

1.6 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.7 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

5.1 ,This test method is used to identify the presence of elastic response in a binder and the change in elastic response at two different stress levels. Non-recoverable creep compliance has been shown to be an indicator of the resistance of an asphalt binder to permanent deformation under repeated load.

5.2 ,This test method is also useful as a surrogate for other test methods used to measure elasticity in asphalt binders such as Test Method D5801 (toughness and tenacity), Test Method D6084/D6084M (elastic recovery), and Test Method D7175 (DSR phase angle).

Note 2: ,The quality of the results produced by this standard are dependent on the competence of the personnel performing the procedure and the capability, calibration, and maintenance of the equipment used. Agencies that meet the criteria of Specification D3666 are generally considered capable of competent and objective testing, sampling, inspection, etc. Users of this standard are cautioned that compliance with Specification D3666 alone does not completely ensure reliable results. Reliable results depend on many factors, following the suggestions of Specification D3666 or some similar acceptable guideline provides a means of evaluating and controlling some of those factors.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee D04.44 - Committee D04 on Road and Paving Materials
Published by ASTM
Document type Standard
Theme ,Binders. Sealing materials
ICS 91.100.50 : Binders. Sealing materials
Number of pages 4
Replace ASTM D7405-15
Set ASTM Volume 04.03 - Multi-User - Single-Site Online
Document history ,,,,
Keyword D7405

You may also be interested in the following product(s)