ASTM D6172/D6172M-18

ASTM D6172/D6172M-18

Standard Test Method for Determining the Volume of Bulk Materials Using Contours or Cross Sections Created by Direct Operator Compilation Using Photogrammetric Procedures

Availability: In stock

€51.00

Details

1.1 ,This test method covers procedures concerning site preparation, technical procedures, quality control, and equipment to direct the efforts for determining volumes of bulk material. These procedures include practical and accepted methods of volumetric determination.

1.2 ,This test method allows for only two volume computation methods.

1.2.1 ,Contour Test Method—,See 8.1.1 and 9.1.

1.2.2 ,Cross-Section Test Method—,See 8.1.2 and 9.2.

1.2.3 ,This test method requires direct operator compilation for both contours and cross-section development.

1.2.4 ,The use of Digital Terrain Model software and procedures to create contours or cross sections for volume calculation is NOT encompassed in this test method.

Note 1: ,A task group has been established to develop a test method for Digital Terrain Modeling (DTM) procedures. It will address all known data collection procedures such as conventional ground survey, photogrammetry, geodetic positioning satellite (GPS), and so forth.

1.3 ,The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system are not necessarily exact equivalents, therefore, to ensure conformance with the standard, each system shall be used independently of the other, and values from the two systems shall not be combined.

1.4 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

1.5 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

4.1 ,This test method audits the volume of material in a stockpile and is used with a density value to calculate a tonnage calculation value used to compare the book value to the physical inventory results. This test method is used to determine the volume of coal or other materials in a stockpile.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee D05.07 - Committee D05 on Coal and Coke
Published by ASTM
Document type Standard
Theme ,Measurement of volume, mass, density, viscosity
ICS 17.060 : Measurement of volume, mass, density, viscosity
Number of pages 8
Replace ASTM D6172-98(2010)
Set ASTM Volume 05.06 - Multi-User - Single-Site Online
Document history ,,
Keyword D6172/D6172M

You may also be interested in the following product(s)