ASTM D2305-18

ASTM D2305-18

Standard Test Methods for Polymeric Films Used for Electrical Insulation

Availability: In stock

€51.00

Details

1.1 ,These test methods cover the testing of homogeneous organic polymer films not over 2.4 mm (95 mils) thick that are to be used for electrical insulation.

1.2 ,These test methods are not necessarily applicable to testing films in combinations with a coating, another film, or with other types of substrate, such as fabrics or papers.

1.3 ,The values stated in SI units are the standard. The values in parentheses are provided for information only.

1.4 ,The procedures appear in the following sections:

Procedure

Sections

Conditioning

 ,6 and 7

Dielectric Breakdown Voltage &, Dielectric Strength

21 to 26

Extractables

65 to 70

Heat-Seal Strength

59 to 64

Permittivity and Dissipation Factor

42 to 47

Resistance Method for Measuring the Tendency to

 ,

 ,Corrode Metals

38 to 41

Sampling

5

Shrinkage

48 to 53

Strain Relief

13 to 20

Surface Resistivity

27 to 31

Tensile Properties

12

Thickness

 ,8 to 11

Volume Resistivity

32 to 37

Water Absorption

53 to 58

1.5 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.

Note 1: ,These test methods are similar to IEC 60674–,2.

1.6 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Significance and Use:

6.1 ,Many electrical and physical properties of films vary significantly with changes in temperature and humidity. Properties of thin plastic films can change very rapidly, therefore, the specimen needs to be in the stated conditioning environment when the test is being performed. When the test is performed in a different environment, note these conditions and the time of exposure to this new environment.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee D09.07 - Committee D09 on Electrical and Electronic Insulating Materials
Published by ASTM
Document type Standard
Theme ,Plastic and rubber insulating materials
ICS 29.035.20 : Plastics and rubber insulating materials
Number of pages 8
Replace ASTM D2305-10
Set ASTM Volume 10.01 - Multi-User - Single-Site Online
Document history ,,
Keyword D2305

You may also be interested in the following product(s)