| Name | Support | Language | Availability | Edition date | Price | ||
|---|---|---|---|---|---|---|---|
|
PDF |
English |
Active |
4/1/2023 |
€54.00 |
|
||
|
PDF |
English |
Active |
4/1/2023 |
€65.00 |
|
||
Details
1.1 This specification covers composition, thickness, fabricating procedures, and physical property requirements for glass fiber reinforced thermoset polyester, vinyl ester, or other qualified thermosetting resin laminates comprising the materials of construction for RTP corrosion-resistant tanks, piping, and equipment. This specification is limited to fabrication by contact molding.
Note 1: The laminates covered by this specification are manufactured during fabrication of contact-molded RTP tanks, piping, and other equipment.
Note 2: There is no known ISO equivalent to this standard.
1.2 The values stated in inch-pound units are to be regarded as standard. The SI values given in parentheses are conversions from inch-pound units and are for information only.
1.3 The following safety hazards caveat pertains only to the test method portion, Section 8, of this specification: This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers composition, thickness, fabricating procedures, and physical property requirements for glass fiber reinforced thermoset polyester, vinyl ester, or other qualified thermosetting resin laminates comprising the materials of construction for RTP corrosion-resistant tanks, piping, and equipment. This specification is limited to fabrication by contact molding. Laminates shall be classified according to type, class, and grade: Types I and II, Classes P and V. Tensile strength and tangent modulus of elasticity, flexural strength, glass content, thickness, hardness, chemical resistance, and surface flame-spread classification tests shall be performed to conform to the specified requirements.
Additional Info
| Author | American Society for Testing and Materials (ASTM International) |
|---|---|
| Committee | D20.23 - Committee D20 on Plastics |
| Published by | ASTM |
| Document type | Standard |
| Theme | ,Laminated sheets |
| ICS | 83.140.20 : Laminated sheets
|
| Number of pages | 7 |
| Replace | ASTM C582-09(2016) + Redline |
| Set | ASTM Volume 08.03 - Multi-User - Single-Site Online |
| Keyword | C582 |
