| Name | Support | Language | Availability | Edition date | Price | ||
|---|---|---|---|---|---|---|---|
|
PDF |
English |
Active |
4/1/2023 |
€54.00 |
|
||
|
PDF |
English |
Active |
4/1/2023 |
€65.00 |
|
||
Details
1.1 This specification establishes the requirements for seamless copper tube in coils, suitable for use in refrigeration and air conditioning or other uses, such as oil lines and gasoline lines.
1.2 Units—The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 The tube shall be produced of the following coppers:
| Copper Alloy | Previously Used | Type of Copper |
|
|
|
|
| C10200 | OF? | Oxygen-free without residual deoxidantsA |
| C10300 | ... | Oxygen-free, extra low phosphorusA |
| C10800 | ... | Oxygen-free, low phosphorusA |
| C12000 | DLP | Phosphorized, low residual phosphorus |
| C12200 | DHP | Phosphorized, high residual phosphorus |
1.4 The following safety hazards caveat pertains to the test method portion, Section 17, of this specification. This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.5 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This standard specification establishes the requirements for seamless copper tube coils, suitable for use in refrigeration and air conditioning or other uses, such as oil lines and gasoline lines. The material of manufacture shall be cast billet, bar, tube and so forth of Copper Alloys No. C10200, C10300, C10800, C12000, or C12200. The tube shall be manufactured by such hot and cold working processes needed to produce a homogeneous, uniform wrought structure. The tube shall be cold drawn to the prescribed finish size and wall thickness. When the cold-drawn temper is required, the final drawing operation shall conform to the specified temper properties. When the annealed temper is required, the tube shall be annealed after the final cold draw to the specified temper properties. The product shall conform to the prescribed electrical mass resistivity, tensile strength, yield strength, Rockwell hardness, and expansion. Each tube shall be subjected to an eddy-current test. Particular coppers shall be tested to meet the cuprous oxide, embrittlement, and cleanness requirements.
Additional Info
| Author | American Society for Testing and Materials (ASTM International) |
|---|---|
| Committee | B05.04 - Committee B05 on Copper and Copper Alloys |
| Published by | ASTM |
| Document type | Standard |
| Theme | ,Copper products |
| ICS | 77.150.30 : Copper products
|
| Number of pages | 7 |
| Replace | ASTM B743-12(2020) |
| Set | ASTM Volume 02.01 - Multi-User - Single-Site Online |
| Keyword | B743 |
