| Name | Support | Language | Availability | Edition date | Price | ||
|---|---|---|---|---|---|---|---|
|
PDF |
English |
Active |
4/1/2020 |
€51.00 |
|
||
|
PDF |
English |
Active |
4/1/2020 |
€61.00 |
|
||
Details
1.1 ,This specification establishes the requirements for phosphorized copper wire bars, billets, and cakes.
Note 1: ,Wire bars furnished under this specification do not conform in dimensions with that furnished under Specification B5.
1.2 ,Units—,The values stated in inch-pound units are to be regarded as standard. The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard.
1.3 ,The following safety hazard caveat pertains only to the test method in 14.2 and 14.3 in this specification.
1.3.1 ,This standard does not purport to address all of the safety concerns, if any, associated with its use. It is the responsibility of the user of this standard to establish appropriate safety, health, and environmental practices and determine the applicability of regulatory limitations prior to use.
1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification establishes the requirements for phosphorized copper in refinery shapes such as wire bars, billets, and cakes. The product furnished shall be produced from one of the following copper UNS Nos.: C10300, C10800, C12000, C12200, and C14200. Billets shall be supplied sheared on one end with the other end flat or with both ends flat depending on the specified diameter. The product shall conform to the chemical composition requirements prescribed for copper and silver, phosphorus, and arsenic. The electrical mass resistivity for phosphorized copper in annealed condition is specified. The requirements for chemical analysis, reverse bend test (hydrogen embrittlement susceptibility), and microscopical examination are detailed including sampling and specimen preparation.
Additional Info
| Author | American Society for Testing and Materials (ASTM International) |
|---|---|
| Committee | B05.07 - Committee B05 on Copper and Copper Alloys |
| Published by | ASTM |
| Document type | Standard |
| Theme | ,Copper products |
| ICS | 77.150.30 : Copper products
|
| Number of pages | 5 |
| Replace | ASTM B379-11(2018) |
| Set | ASTM Volume 02.01 - Multi-User - Single-Site Online |
| Document history | ,,, |
| Keyword | B379 |
