ASTM A995/A995M-20 + Redline

ASTM A995/A995M-20 + Redline

Standard Specification for Castings, Austenitic-Ferritic (Duplex) Stainless Steel, for Pressure-Containing Parts

Availability: In stock

€61.00

Details

1.1 ,This specification covers austenitic-ferritic (duplex) stainless steel castings for valves, flanges, fittings, and other pressure-containing parts.

1.2 ,The duplex stainless steels offer a combination of enhanced mechanical properties and corrosion resistance when properly balanced in composition and properly heat treated. Ferrite levels are not specified, but these grades will develop a range of approximately 30 to 60 ,% ferrite with the balance austenite. It is the responsibility of the purchaser to determine which grade shall be furnished depending on design and service conditions, mechanical properties, and corrosion-resistant characteristics.

Note 1: ,Because of the possibility of precipitation of embrittling phases, the grades included in this specification are not recommended for service at temperatures above 600 ,°,F [315 ,°,C].

1.3 ,The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in nonconformance with the standard.

1.4 ,This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.


Rationale:

This specification covers austenitic-ferritic (duplex) stainless steel castings for valves, flanges, fittings, and other pressure-containing parts. The grades of steels covered here are: Grade 1B, Grade 2A, Grade 3A, Grade 4A, Grade 5A, and Grade 6A. The steel castings shall be heat-treated up to required temperature and shall undergo water quenching or rapid cooling by other means after heating. Heat and product analyses shall be performed wherein specimens shall conform to required chemical composition of carbon, manganese, silicon, phosphorus, sulfur, chromium, nickel, molybdenum, copper, tungsten, and nitrogen. All steels shall undergo tension test, and shall conform to the following mechanical requirements: tensile strength, yield strength, and elongation.

Additional Info

Author American Society for Testing and Materials (ASTM International)
Committee A01.18 - Committee A01 on Steel, Stainless Steel and Related Alloys
Published by ASTM
Document type Standard
Theme ,Iron and steel castings
ICS 77.140.80 : Iron and steel castings
Number of pages 6
Replace ASTM A995/A995M-19 + Redline
Set ASTM Volume 01.02 - Multi-User - Single-Site Online
Document history ,,,,,
Keyword A995/A995M

You may also be interested in the following product(s)