| Name | Support | Language | Availability | Edition date | Price | ||
|---|---|---|---|---|---|---|---|
|
PDF |
English |
Active |
9/1/2022 |
€51.00 |
|
||
|
PDF |
English |
Active |
9/1/2022 |
€61.00 |
|
||
Details
1.1 This specification covers three grades of seam-welded, round, tapered steel tubes for structural use. Grades A and B are of low-carbon steel or high-strength low-alloy steel composition and Grade C is of weather-resistant steel composition.
1.1.1 The product may be modified from its round cross section into other shapes without subsequent retesting.
1.2 This tubing is produced in welded sizes in a range of diameters from 2?3/8 to 30 in. [60 to 762 mm] inclusive. Wall thicknesses range from 0.1046 to 0.375 in. [2.66 to 9.53 mm]. Tapers are subject to agreement with the manufacturer.
1.3 The values stated in either SI units or inch-pound units are to be regarded separately as standard. The values stated in each system may not be exact equivalents, therefore, each system shall be used independently of the other. Combining values from the two systems may result in non-conformance with the standard.
1.4 This international standard was developed in accordance with internationally recognized principles on standardization established in the Decision on Principles for the Development of International Standards, Guides and Recommendations issued by the World Trade Organization Technical Barriers to Trade (TBT) Committee.
Rationale:
This specification covers three grades of seam-welded, round, tapered steel tubes for structural use. Grades A and B are of low-carbon steel or high-strength low-alloy steel composition and Grade C is of weather-resistance steel composition. The tube steel shall be hot-rolled aluminum-semikilled or fine-grained killed sheet or plate manufactured by one or more of the following processes: open-hearth, basic-oxygen, or electric-furnace. The tubes shall be made from trapezoidal sheet or plate that is preformed and then seam welded. They shall be brought to final size and properties by roll compressing cold on a hardened mandrel. A tensile test shall be done to determine the yield strength and the ultimate tensile strength of the tubes.
Additional Info
| Author | American Society for Testing and Materials (ASTM International) |
|---|---|
| Committee | A01.09 - Committee A01 on Steel, Stainless Steel and Related Alloys |
| Published by | ASTM |
| Document type | Standard |
| Theme | ,Steel pipes and tubes for specific use |
| ICS | 77.140.75 : Steel pipes and tubes for specific use
|
| Number of pages | 5 |
| Replace | ASTM A595/A595M-18 + Redline |
| Set | ASTM Volume 01.01 - Multi-User - Single-Site Online |
| Keyword | A595/A595M |
